By default, RRAS is configured to accept Internet Protocol version 4 (IPv4) connections only. Use this procedure to configure RRAS to add support for Internet Protocol version 6 (IPv6) connections.
Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.
|
To enable IPv6 connections |
-
Right-click Your Server Name, and then click Properties. If you are using Server Manager, right-click Routing and Remote Access, and then click Properties.
-
On the General tab, click IPv6 Router or IPv6 Remote access server, or both, depending on your requirements.
-
If you are configuring remote access for IPv6, on the IPv6 tab, type the IPv6 prefix that is to be assigned to incoming IPv6 remote clients (for example: 2001:1234:5678:90ab::).
-
Click OK, and then click Yes to restart RRAS.
Additional references
- Configuring RRAS
- Virtual Private
Networking
- IPv6 Addressing
(http://go.microsoft.com/fwlink/?linkid=140606)
- IPv6 Routing
(http://go.microsoft.com/fwlink/?linkid=140615)