The following procedures are used to configure the Routing and Remote Access service (RRAS).

• Install RRAS
  
  
• Open the RRAS MMC Snap-in
  
  
• Configure a Dial-Up Remote Access Server
  
  
• Configure a Firewall for VPN Traffic (http://go.microsoft.com/fwlink/?linkid=140709)
  
  
• Configure the Way RRAS Assigns IP Addresses to VPN Clients
  
  
• Configure Logging Levels for RRAS
  
  
• Configure Network Access Protection Enforcement for VPN
  
  
• Configure Ports for Remote Access
  
  
• Configure RRAS with a Computer Authentication Certificate
  
  
• Configure Static Packet Filters (http://go.microsoft.com/fwlink/?linkid=140713)
  
  
• Configure the IPv4 DHCP Relay Agent
  
  
• Configure the IPv6 DHCP Relay Agent
  
  
• Configure TCP/IP on the RRAS Server
  
  
• Create a Demand-Dial Interface
  
  
• Create a Static Route
  
  
• Enable and Configure NAT
  
  
• Enable and Configure RIP
  
  
• Enable IPv6 Remote Access
  
  
• Enable RRAS as a LAN and WAN Router
  
  
• Enable RRAS as a VPN Server
  
  
• Enable RRAS as a VPN Server and a NAT Router
  
  
• Remove RRAS from a Server
  
  
• View Information in RRAS
  
  

Additional references