This page appears if you select VPN on the Remote Access page of the wizard.

Use this page to identify the interface that connects to the public network.

Dialog box element	Description
Network Interfaces	Select the interface that remote access clients will use to access the RRAS server. This is typically the interface connected to the public Internet.
Enable security on the selected interface by setting up static packet filters	If you select this check box, the Routing and Remote Access service is automatically configured with filters that allow only virtual private network (VPN) traffic into the selected network interface. To customize the static filters, see IPv4 - General - Interface - Properties Page - General Tab or IPv6 - General - Interface - Properties Page. For more information about static filters, see Configure Static Packet Filters (http://go.microsoft.com/fwlink/?linkid=140713).

Dialog box element

Description

Network Interfaces

Select the interface that remote access clients will use to access the RRAS server. This is typically the interface connected to the public Internet.

Enable security on the selected interface by setting up static packet filters

If you select this check box, the Routing and Remote Access service is automatically configured with filters that allow only virtual private network (VPN) traffic into the selected network interface. To customize the static filters, see IPv4 - General - Interface - Properties Page - General Tab or IPv6 - General - Interface - Properties Page. For more information about static filters, see Configure Static Packet Filters (http://go.microsoft.com/fwlink/?linkid=140713).

Additional references

RRAS Setup Wizard - Remote Access - VPN Connection Page