This section describes the pages in the Routing and Remote Access Setup Wizard.

To get to this wizard

1. Open Server Manager. Click Start, click Administrative Tools, and then click Server Manager.

2. If you have not yet installed RRAS, follow the procedure in Install RRAS.

3. After RRAS is installed, right-click Routing and Remote Access, and then click Configure and Enable Routing and Remote Access.

• RRAS Setup Wizard - Configuration Page
  
  
• RRAS Setup Wizard - Remote Access
  
  
• RRAS Setup Wizard - Remote Access - Dial-up - Network Selection
  
  
• RRAS Setup Wizard - Remote Access - IP Address Assignment
  
  
• RRAS Setup Wizard - Remote Access - Managing Multiple Remote Access Servers
  
  
• RRAS Setup Wizard - Remote Access - VPN Connection Page
  
  
• RRAS Setup Wizard - Custom Configuration
  
  
• RRAS Setup Wizard - Address Range Assignment
  
  
• RRAS Setup Wizard - NAT Internet Connection Page
  
  
• RRAS Setup Wizard - Demand-Dial Connections Page
  
  
• RRAS Setup Wizard - Closing Page
  
  

Additional references