Enables or disables the automount feature.
For examples of how this command can be used, see Examples.
Syntax
automount [enable] [disable] [scrub] [noerr]
Parameters
| Parameter | Description |
|---|---|
|
enable |
Enables Windows to automatically mount new basic volumes that are added to the system and to assign them drive letters. |
|
disable |
Prevents Windows from automatically mounting any new basic volumes that are added to the system. |
|
scrub |
Removes volume mount point directories and registry settings for volumes that are no longer in the system. This prevents volumes that were previously in the system from being automatically mounted and given their former volume mount point(s) when they are added back to the system. |
|
noerr |
For scripting only. When an error is encountered, DiskPart continues to process commands as if the error did not occur. Without this parameter, an error causes DiskPart to exit with an error code. |
Remarks
- When the automount feature is enabled (the default), Windows
automatically mounts the file system for a new basic volume when it
is added to the system and then assigns a drive letter to the
volume.
- In storage area network (SAN) configurations, disabling
automount prevents Windows from automatically mounting or assigning
drive letters to any new basic volumes that are visible to the
system.
Examples
To see if the automount feature is enabled, type:
automount
To enable the automount feature, type:
automount enable
To disable the automount feature, type:
automount disable