You can change a UDDI Services Web server's database in a distributed installation. If you change a Web server's database connection to a database server that is in a different site, you change the site to which that Web server belongs. You cannot change the database connection on a Web server that is part of a stand-alone site.

Note

The UDDI Services Database must be installed on a computer before a UDDI Services Web server can be connected to it.

Membership in Administrators, or equivalent, is the minimum required to complete this procedure. Review details about using the appropriate accounts and group memberships at http://go.microsoft.com/fwlink/?LinkId=83477.

To change a Web server's database

  1. Click Start, point to All Programs, point to Microsoft UDDI Services, and then click UDDI Services Management Console.

  2. In the console tree, click the UDDI Services Web server that you want to configure.

  3. On the Action menu, click Properties.

  4. Click the Database Connection tab.

  5. In Write operations computer, click Change.

  6. Select the computer that hosts the UDDI Services Database component that this Web server will use for write operations by doing one of the following:

    • Click Local computer (the one this console is running on).

    • Click Another computer, and then type the name or IP address of the remote UDDI Services Database server.

  7. In Read operations computer, click Change.

  8. Click the computer that hosts the UDDI Services Database component that this Web server will use for read operations by doing one of the following:

    • Click Local computer (the one this console is running on).

    • Click Another computer, and then type the name or IP address of the remote UDDI Services Database server.

  9. Click OK.

Additional considerations

Additional references

  • Remove a Web Server from a Site
  • Managing a UDDI Services Notification Server