You can use commands in the Netsh ras context to configure all aspects of remote access. The Netsh commands for remote access provide the same functionality as the Routing and Remote Access console, and the commands can be run manually at the netsh prompt or in scripts and batch files.

To run these commands from the command prompt, you must either enter the netsh ras context or prepend the context to the command. For example, if you are at the command prompt but have not typed netsh and then ras to enter the netsh ras context, you must type:

netsh ras command

Where command is the command that you want to run, including all of the required parameters for the command.

For more information about Netsh, see Netsh Overview and Enter a Netsh Context.

For information on how to interpret netsh command syntax, see Formatting Legend.

Netsh remote access command reference

---