This section contains the following commands:
- add
- delete
- reset
- set interface
- set relay
- set routing
- set state
- show interface
- show relay
- show routing
- show state
Interface 6to4 commands
The following entries provide details for each command.
add
Adds an interface to the router. For full interfaces, a phone book entry with the same name must already exist on the system.
Syntax
add [name=] Name [[type=]full]
Parameters
- name
- Required. Specifies the name of the interface to be added.
- type
- Optional. Specifies that a demand dial interface is created when full is designated.
Examples
Following is an example of the add command that creates a demand-dial interface.
add name="Demand-Dial Interface" type=full
delete
Deletes an interface from the router.
Syntax
delete [ name= ] Name
Parameters
- name
- Required. Specifies the name of the interface to be deleted.
Examples:
The following example command deletes a demand-dial interface at the router
delete name="Demand-Dial Interface"
reset
Deletes all of the interfaces that can be added through this context.
Syntax
reset
set interface
Sets 6to4 interface configuration information.
Syntax
set interface [ name= ] Name [ [ routing= ]( enabled | disabled | default )]
Parameters
- name
- Required. Specifies the interface name.
- routing
- Optional. Specifies whether to act as a router.
Examples
Following is an example of the set interface command.
set interface "Private" enabled
set relay
Sets 6to4 relay information.
Syntax
set relay [ [ name= ]( Name | default )] [ [ state= ] ( enabled | disabled | automatic | default ) ] [[ interval= ] Integer ]
Parameters
- name
- Optional. Specifies the name of the 6to4 relay.
- state
- Optional. Specifies whether relay name resolution is enabled or disabled.
- interval
- Optional. Specifies an integer that is the resolution interval (in minutes).
Examples
Following is an example of the set relay command.
set relay 6to4.ipv6.org. enabled 1440
set routing
Sets 6to4 routing information.
Syntax
set routing [ [ routing= ]( enabled | disabled | automatic | default ) ] [ [ sitelocals= ] (enabled | disabled | default ) ]
Parameters
- routing
- Optional. Specifies the state of 6to4 routing.
- sitelocalsq
- Optional. Specifies whether to use Site-Local addresses.
Examples
Following are two examples of the set routing command.
set routing default default
set routing routing=enabled sitelocals=enabled
set state
Sets the 6to4 configuration state.
Syntax
set state [ [ state= ] ( enabled |disabled | automatic | default ) ] [ [ undoonstop= ] ( enabled | disabled | default ) ]
Parameters
- state
- Optional. Specifies whether 6to4 is enabled.
- undoonstop
- Optional. Specifies whether 6to4 is disabled on service stop.
Examples
Following are two examples of the set state command.
set state default default
set state state=enabled undoonstop=disabled
show interface
Displays the 6to4 interface configuration information.
Syntax
show interface
show relay
Displays the 6to4 relay information.
Syntax
show relay
show routing
Displays the 6to4 routing state.
Syntax
show routing
show state
Displays the 6to4 state.
Syntax
show state