You can use the netsh commands for BranchCache to configure BranchCache in Windows Server® 2008 R2 and Windows® 7.

To run these commands from the command prompt, you must either enter the netsh branchcache context or prepend the context to the command. For example, if you are at the command prompt but have not typed netsh and then branchcache to enter the netsh branchcache context, you must type:

netsh branchcache command

Where command is the command that you want to run, including all of the required parameters for the command.

BranchCache is a new feature of Windows Server 2008 R2 and Windows® 7. BranchCache is not available in Windows Server® 2008 or Windows Vista®.

Learn more

The following section provides Netsh commands for BranchCache in Windows Server 2008 R2 and Windows 7.

Netsh Commands for BranchCache in Windows Server 2008 R2