Enabling and disabling the RD Gateway enforcement client

To enable and disable the RD Gateway enforcement client by using the Windows interface

  1. To open the NAP Client Configuration console, click Start, click All Programs, click Accessories, click Run, type NAPCLCFG.MSC, and then click OK.

  2. Click Enforcement Clients.

  3. Right-click RD Gateway Quarantine Enforcement Client, and then click Enable or Disable.

Additional considerations

  • To perform this procedure, you must be a member of the Administrators group on the local computer, or you must have been delegated the appropriate authority. If the computer is joined to a domain, members of the Domain Admins group might be able to perform this procedure. As a security best practice, consider using Run as to perform this procedure.

To enable or disable the RD Gateway enforcement client by using a command line

  1. To open a command prompt, click Start, click All Programs, click Accessories, and then click Command Prompt.

  2. To enable or disable the RD Gateway enforcement client, do one of the following:

    1. To enable the RD Gateway enforcement client, type: netsh nap client set enforcement ID = 79621 ADMIN = "ENABLE"

    2. To disable the RD Gateway enforcement client, type: netsh nap client set enforcement ID = 79621 ADMIN = "DISABLE"

Additional considerations

  • To perform this procedure, you must be a member of the Administrators group on the local computer, or you must have been delegated the appropriate authority. If the computer is joined to a domain, members of the Domain Admins group might be able to perform this procedure. As a security best practice, consider using Run as to perform this procedure.

Additional references

  • Enable and Disable the IPsec Enforcement Client
  • Enable and Disable the EAP Enforcement Client