Specifying the detail that is recorded in the NAP trace log

To specify the detail that is recorded in the NAP trace log by using the Windows interface

To open the NAP Client Configuration console, click Start, click All Programs, click Accessories, click Run, type NAPCLCFG.MSC, and then click OK.
Right-click NAP Client Configuration(Local Computer), and then click Properties.
In the NAP Client Configuration(Local Computer) Properties dialog box, confirm that Enabled is selected.
Under Specify the level of detail at which the tracing logs are written, select Basic, Advanced, or Debug.

To perform this procedure, you must be a member of the Administrators group on the local computer, or you must have been delegated the appropriate authority. If the computer is joined to a domain, members of the Domain Admins group might be able to perform this procedure. As a security best practice, consider using Run as to perform this procedure.

To specify the detail that is recorded in the NAP trace log by using a command line

To open a command prompt, click Start, click All Programs, click Accessories, and then click Command Prompt.
To configure NAP tracing, do one of the following:
1. To configure NAP tracing so that basic information is recorded, type: netsh nap client set tracing state = enable level = basic
2. To configure NAP tracing so that advanced information is recorded, type: netsh nap client set tracing state = enable level = advanced
3. To configure NAP tracing so that debug information is recorded, type: netsh nap client set tracing state = enable level = verbose

To perform this procedure, you must be a member of the Administrators group on the local computer, or you must have been delegated the appropriate authority. If the computer is joined to a domain, members of the Domain Admins group might be able to perform this procedure. As a security best practice, consider using Run as to perform this procedure.

Additional references