Follow this procedure to add a member to a replication group.
|
To add a member to a replication group |
-
Click Start, point to Administrative Tools, and then click DFS Management.
-
In the console tree, under the Replication node, right-click a replication group, and then click New Member.
-
Follow the instructions in the New Member Wizard.
Before making a member of a replication group read-only, review the Performance Considerations section of Make a Replicated Folder Read-Only on a Particular Member.
To include a failover cluster in a replication group, see Add a Failover Cluster to a Replication Group.
|
Note |
|
Configuration changes are not applied immediately to all
members. The new configuration must be replicated to all domain
controllers, and each member in the replication group must poll its
closest domain controller to obtain the changes. The amount of time
this takes depends on AD DS replication latency and the long
polling interval (60 minutes) on each member. To poll immediately
for configuration changes, open a command prompt window and then
type the following command once for each member of the replication
group: |